Software MBus-CT

Software MBus-CT (M-Bus Configuration Tool) company METZ CONNECT is used to configure the M-Bus devices S0 / M and T / M.

S0 / M — four-pulse converter, converts the data into pulses with M-Bus protocol. T / M — four-converter RTD signals into M-Bus protocol. Modules are used to extend the functionality of energy metering systems.

MBus-CT software supports the address setting function, the transmission speed and the temperature characteristics. No matter how many nodes in the M-Bus bus — one or more. With built-in scan function, the software can also be used as a diagnostic tool.

No need to install software. The executable can be run from the hard drive or removable media (such as USB).
To connect your computer to the M-Bus is required M-Bus Master (level converter) connected to the COM or USB port.

Minimum System Requirements: WinXP (32/64 bit), Win7 (32/64 bit), M-Bus Master (level converter).
Version available in German.

The result is a network scanning M-bus

Module Configuration WindowT/M

Network Diagram padsM-Bus с использованием распределительных коробок  MYD 4M и MYD 2M2V